MAX3373EEBL+T, Низковольтный транслятор уровня, 1.2В до 5.5В питание, 30нс задержка, UCSP-9

The MAX3373EEBL+T from Maxim Integrated Products is a ±15kV ESD protected, dual low voltage level translator in 9 pin UCSP package. This translator provides level shifting necessary to allow data transfer in a multivoltage system. Externally applied voltages, VCC and VL, set logic levels on either side of the device. A low-voltage logic signal present on VL side of device appears as a high voltage logic signal on VCC side of device and vice-versa. The bidirectional level translator utilizes a transmission gate based design to allow data translation in either direction (VL ? VCC) on any single data line. It operates at a guaranteed data rate of 8Mbps over the entire specified operating voltage range. It is used at SPI, MICROWIRE® and I2C level translation, low voltage ASIC level translation, smart card readers, cell-phone cradles portable POS systems, portable communication devices, low-cost serial interfaces, cell phones, GPS and telecommunications equipment.

• Operation down to +1.2V on VL and (1.2 to 5.5V) VL, (1.65 to 5.5V) VCC supply range
• Operating temperature range from -40°C to 85°C
• ±15kV ESD protection on I/O VCC lines
• Ultra low 1µA supply current in three-state output mode
• Low-quiescent current (130µA typ)
• Thermal short circuit protection

Полупроводники - Микросхемы\Логика\Схемы Сдвига Уровня

Технические параметры